Woodworking laminating machine is the heating plasticized PVC thermoplastic coil (PVC film), leather, wood veneer and other absorb and cover on the density board, stone and other plates, to make various shapes of senior cabinet doors, wardrobe doors, sliding doors, photo frames and other products. Principle of plasticizing machine: The molding process is mainly the use of vacuum pump vacuum suction will heat softened PVC thermoplastic plastic coil, through vacuum plasticizing into various shapes of sheets.
The principle of cabinet laminating machine
Principle of blister molding machine: Blister molding, also known as thermoplastic molding, this molding process is mainly the use of vacuum pump vacuum suction will be heated after softening PVC thermoplastic plastic coil, through vacuum blister into various shapes of sheet and so on.
Product application scale wide cabinet door blister, wardrobe door blister, sliding door blister, flat door blister, non-paint door blister, molded door blister, picture frame blister, computer desk blister, massage chair blister, tea cabinet blister, hot pot table blister, leather soft bag blister, wood veneer blister, stone PVC blister, etc.
Use and operation of vacuum laminating machine
1. The equipment should be operated by special personnel, and the operators should be trained to be familiar with the equipment performance, master the film coating process and understand the operation method, and pay attention to safe production.
2. Turn on the temperature switch and set the temperature, vacuum degree and preheating time according to the needs of the production process. If the vacuum pump is turned on for the first time every day or after a long shutdown, the switch should be clicked twice and then turned on, which is conducive to the normal use of the vacuum pump.
3. Smooth the surface of the coated workpiece, evenly spray PVC film special adhesive, put the prepared workpiece on the expansion plate dedicated to the suction cover station, raise the frame of the PVC film, lay the PVC film, put down the pressure frame immediately lock the pressure frame, the PVC film is required to be smooth, no damage, no air leakage phenomenon and no debris.
4. The suction cover station into the warehouse to the heating control box, heating the PVC film according to the preheating time, after the set time, the vacuum pump will automatically open for suction cover, after the suction cover is in place, continue to maintain a constant temperature of 30 ~ 90s (this parameter can be controlled by itself), and then automatically out of the warehouse, the automatic cooling function will be carried out at the same time, until the cooling can take out the workpiece.
5. Carefully record the process parameters of various adsorption materials and special adhesives used in the production process, which will be helpful for future work.
